Glycol Maxi 310 4 Product Shelf Cooler With Recirc
This factory re-built (reconditioned) Maxi 310 4 product glycol cooler- provides an almost equal longevity compared with new, fitted with all new mechanical parts and a lovely new cabinet whilst maintaining the legendary Maxi performance. Allowing for greater savings when compared with buying brand new.
The Maxi 310 4 product glycol cooler used for lager and ciders (not used with ales and stouts because of chill haze). Equipped with 2 x long 6-metre integral cooling coils, and 2 x short 4-metre integral cooling coils, and a recirculating pump for trace cooling to tap. Fitted with a variable thermostat to control the level of cooling for serving your sub zero beverage.
Please Note: For mobile bars, Home bars, garden bars and Man cave/She hut bars etc - each Long 6-metre cooling coil will reduce the incoming beverage temperature by up to 15 degrees Celsius and each short 3-metre reduces up to 7.5 degrees Celsius.. In order to reach desired serving temp calculate the keg temperature vs cooling coil length.
- e.g. A keg stored in a cellar at 12 degrees centigrade using one cooling coil will serve up to -3 degrees.
e.g If the kegs are not stored in a chilled cellar a keg stored at 20 degrees using one cooling coil will serve at 5 degrees centigrade so you will then need to double up using one long and one short to end up at -2.5 degrees Celsius. However the serving temp will never be lower than the dialled in temperature at the variable thermostat provided, so if it's too low over the two cooling coils back the thermostat off until you reach the desired serving temp.
Please use this chart as a guid to help calculate and prevent beverage freezing point, note the ABV (alcohol by volume) percentage of the product serving and adjust thermostat dial accordingly (must set temperature higher than):
If you're unsure please contact us with the product you're planing to dispense with its ideal serving temperature and we will be happy to assist in selecting the correct cooler or setup.
This factory re-built cooler is re-conditioned as follows:
|Product coils:||Serviced or new where necessary|
|Water bath and refrigerant lines:||Reconditioned|
|Agitator pump:||Reconditioned or New|
|Warranty:||1 year back to base|
|Recirculation type No-6 pump with 3/8" outlets. Pump lift:||5-Metres|
|3/8" Product cooling coils:||
2 x Long 6-Metres 316 grade stainless steel. (Each coil will reduce incoming temperature up to 15 degrees Celsius)
2 x short 3-metre 316 grade stainless steel. (Each coil will reduce incoming temperature up to 7.5 degrees Celsius)
|Dimensions:||Width 590 x Depth 455 x Height 280mm (Please allow a minimum of 50mm extra space around the cooler for ventilation)|
|Electrical spec:||220-240Vac, Run-2.5Amps Startup-10Amps, 575Watts.|